Methods The electrolyte and cathode layers of the thin film SOFCs were fabricated on 10-μm-thick nickel foil
(to act as an anode). The thin film solid oxide fuel cell fabrication process flow is illustrated in Figure 1, wherein the nickel SAHA nmr foils were treated for a short time in a mixture of acetic, nitric, sulphuric, and phosphoric acids to remove any rolling marks left on the foil surface followed by a degreasing process (acetone, methanol, and DI water). The clean nickel foils were annealed at 650°C for 2 h in an argon atmosphere in order to generate atomic ordering with the lattice (100) direction normal to the foil surface. Layers of yttria-stabilized zirconia (YSZ) electrolyte (approximately 1.5 μm thick) and La0.5Sr0.5CoO3 – δ (LSCO) cathode (approximately 2 μm thick)
were deposited on the nickel foils using pulsed laser deposition (PLD; 248-nm KrF laser) in an initially 96% argon/4% hydrogen atmosphere (to avoid nickel oxidization) and then in an oxygen atmosphere (to yield good oxide stoichiometry) at substrate temperatures of 25°C to 650°C. Hexagonal pores (about 50-μm diameter with 50-μm spacing) were etched in the nickel anode by photolithographic patterning followed by either wet etching (using 0.25 M FeCl3) or electrochemical etching (using 6 M H2SO4) at room temperature (see Figure 1). Figure 1 Schematic diagram for LSCO/YSZ/Ni thin SOFC(s) fabrication process flow. The crystalline structures mTOR inhibitor of the successive layers of the fabricated fuel Protirelin cells were characterized
by X-ray diffraction (XRD) measurements which were Alvocidib manufacturer carried out using a Siemens D-5000 spectrometer (Erlangen, Germany). The XRD scans were done in the standard θ-2θ configuration, using the Cu Kα radiation of wavelength 1.54 Å at scan steps of 0.05°. SEM analysis was carried out using a JEOL (JSM 5410, Akishima, Tokyo, Japan) scanning electron microscope. A computerized testing setup was used to test the fuel cells fuel-air performance (I-V and power output characteristics) as a function of operating temperature. Results and discussion The XRD scans of the different layers of the fabricated samples are shown in Figure 2. The XRD scan of the approximately 1.5-μm-thick YSZ electrolyte film deposited on treated nickel foil by PLD at 650°C (Figure 2a) shows two major peaks: Ni (200) at θ = 51.85° and YSZ (200) at θ = 34.8°. However, the appearance of low-intensity peak at θ = 44.5° indicates a small percentage of the (111) crystalline orientation in Ni. The XRD scan of the 2-μm-thick cathode (LSCO) film deposited on the YSZ/Ni sample by PLD first at 650°C and then at room temperature (Figure 2b) shows an LSCO (200) small broad peak at θ = 43°. The LSCO (100) orientation is more favorable because of its high conductivity compared to other types of crystallographic orientations [9].